Looking for a capable blacksmith to construct 4 daggers to my specifications.
The design has a hollowed hilt, a rivet in the center in of the blade that leads all the way to a hole in the hilt.
The idea here is this; the pommel of the blade is kept a half inch from the hilt with a spring. (Small leather flaps closing the space between). Running down the center of the empty hilt is a metal point that stops a half inch above the opening leading to the Rivet on the blade.
A cork is put between the point and the Rivet’s mouth. Fill the hilt with Poison, Hit the pommel hard enough to puncture the cork Poison pours over the blade (Would require a bit of Flicking of the blade get it out) this can only be done once for obvious reasons.
Here is the design.
I will pay 15k for all four or 3000 a knife.
The design has a hollowed hilt, a rivet in the center in of the blade that leads all the way to a hole in the hilt.
The idea here is this; the pommel of the blade is kept a half inch from the hilt with a spring. (Small leather flaps closing the space between). Running down the center of the empty hilt is a metal point that stops a half inch above the opening leading to the Rivet on the blade.
A cork is put between the point and the Rivet’s mouth. Fill the hilt with Poison, Hit the pommel hard enough to puncture the cork Poison pours over the blade (Would require a bit of Flicking of the blade get it out) this can only be done once for obvious reasons.
Here is the design.
I will pay 15k for all four or 3000 a knife.
Last edited:
